This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
configuration:wlan-client-bridge [2018/03/20 14:59] – [WLAN Client Bridge] juraschek | configuration:wlan-client-bridge [2022/01/03 12:57] (current) – schmitt | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== WLAN Client Bridge ====== | ====== WLAN Client Bridge ====== | ||
- | To bridge a WLAN Client connection with a Ethernet LAN there are some requierments needed. | ||
- | The Wifi Access Point need to Support the 4 Address Frame, which the AP in Netmodule Router does. | ||
- | This Funtionality was introduced | + | To bridge a WLAN Client connection |
+ | The WiFi Access Point as well as the WiFi clients need to support | ||
- | <WRAP center round important 80%> | + | * NB1800 |
- | In the DUAL Mode will only see SSID that are sending on the channel the AP is configured to | + | * NB1810 |
- | </ | + | * NB2700 |
+ | * NB2710 | ||
+ | * NB2800 | ||
+ | * NB2810 | ||
+ | * NB3700 | ||
+ | * NB3701 | ||
+ | * NB3710 | ||
+ | * NB3711 | ||
+ | * NB3800 | ||
+ | |||
+ | Please use the current Version: [[https:// | ||
+ | In case you running a NB800 or NB1601 you can take a look at our [[configuration: | ||
Line 17: | Line 27: | ||
- | {{ : | + | {{ : |
- | {{ : | + | {{ : |
At the IP Settings Page please enable the "4addr frame" and choose the LAN Interface you want to bridge with. | At the IP Settings Page please enable the "4addr frame" and choose the LAN Interface you want to bridge with. | ||
- | {{ : | + | {{ : |
- | ===== Client | + | ===== Client Config ===== |
Please configure your WLAN Client Connection as usual | Please configure your WLAN Client Connection as usual | ||
- | {{ : | + | {{ : |
- | {{ : | + | {{ : |
- | {{ : | + | {{ : |
- | {{ : | + | {{ : |
+ | |||
+ | ==== Activating the CLient Bridge ==== | ||
After the WLAN Connection is set up. Please go to Interfaces-> | After the WLAN Connection is set up. Please go to Interfaces-> | ||
Line 38: | Line 51: | ||
Please define your local LAN Interface to bridge with. | Please define your local LAN Interface to bridge with. | ||
- | {{ : | + | {{ : |
- | {{ : | + | {{ : |
+ | |||
+ | ---- | ||
+ | ===== Other HowTos ===== | ||
+ | [[configuration: | ||