Differences

This shows you the differences between two versions of the page.

--- faq:install-licenses-via-usb-stick [2023/09/28 18:04] – [Files] fachet
+++ faq:install-licenses-via-usb-stick [2023/09/28 18:14] (current) – [How-to] fachet
@@ Line 10: / Line 10: @@
   - Power on the router and wait until it has booted completely. The STAT LED will turn solid green.
   - Plug in the USB stick and the WLAN1 LED will blink slow green.
-  - Afer a few seconds all LEDs will blink green.
+  - When the installation starts, all LEDs blink green and it takes some time.
-**When the update is done the LEDs will be in a stare where STATUS LED is solid yellow and WLAN1 LED is blinking yellow/red. All other LEDs are solid red.**
+Finaly LEDs are
+  * green: ok
+  * yellow: ok, but there was no license change, e.g. installed the same license two times
+  * red: something went wrong. (WLAN1 blinking: red = no license file, yellow = license file corrupt)
-You can now reboot the device and check the status of the licenses with the command:
-cli status license