This is an old revision of the document!

WLAN Client Bridge

To bridge a WLAN Client connection with a Ethernet LAN there are some requierments needed. The Wifi Access Point need to Support the 4 Address Frame, which the AP in Netmodule Router does.

This Funtionality was introduced with the NRSW so please use the current Version:

Access Point Config

Please configure your WLAN Access Point as usual

At the IP Settings Page please enable the “4addr frame” and choose the LAN Interface you want to bridge with.

Client Config

Please configure your WLAN Client Connection as usual

After the WLAN Connection is set up. Please go to Interfaces→Link Managment and edit your WLAN Connection

Please define your local LAN Interface to bridge with.