Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
configuration:wlan-client-bridge [2017/07/04 15:29]
juraschek created
configuration:wlan-client-bridge [2020/10/01 07:40] (current)
juraschek
Line 1: Line 1:
 ====== WLAN Client Bridge ====== ====== WLAN Client Bridge ======
 +
  
 To bridge a WLAN Client connection with a Ethernet LAN there are some requierments needed. ​ To bridge a WLAN Client connection with a Ethernet LAN there are some requierments needed. ​
-The Wifi Access Point need to Support the 4 Address Frame, which the AP in Netmodule Router does.+The Wifi Access Point as well as the wifi clients ​need to support ​4 Address Frame. The configurtion is only possible with the following products:  
 + 
 +  * NB1800 
 +  * NB1810  
 +  * NB2700 
 +  * NB2710  
 +  * NB2800 
 +  * NB2810 
 +  * NB3700 
 +  * NB3701 
 +  * NB3710 
 +  * NB3711  
 +  * NB3800 
 + 
 +Please use the current Version: [[ftp://​share.netmodule.com/​router/​public/​system-software/​4.3/​4.3.0.106/​|4.3.0.106]]. This funtionality was introduced with the NRSW 4.1.0.100. 
 +In case you running a NB800 or NB1601 you can take a look at our [[configuration:​mesh-point|Mesh Network]] funtionality ​
  
-This Funtionality was introduced with the NRSW 4.0.1.103 so please use the current Version: [[ftp://​share.netmodule.com/​router/​public/​system-software/​testing/​4.0/​4.0.1.106/​|4.0.1.106]] 
  
  
Line 20: Line 35:
  
  
-===== CLient Config ​Config =====+===== Client ​Config =====
  
 Please configure your WLAN Client Connection as usual Please configure your WLAN Client Connection as usual
Line 28: Line 43:
 {{ :​configuration:​screenshot_-_07042017_-_05_26_10_pm.png?​nolink |}} {{ :​configuration:​screenshot_-_07042017_-_05_26_10_pm.png?​nolink |}}
 {{ :​configuration:​screenshot_-_07042017_-_05_26_18_pm.png?​nolink |}} {{ :​configuration:​screenshot_-_07042017_-_05_26_18_pm.png?​nolink |}}
 +
 +==== Activating the CLient Bridge ====
 +
  
 After the WLAN Connection is set up. Please go to Interfaces->​Link Managment and edit your WLAN Connection After the WLAN Connection is set up. Please go to Interfaces->​Link Managment and edit your WLAN Connection