Differences

This shows you the differences between two versions of the page.

--- configuration:qos [2016/12/20 11:42] – dotoli
+++ configuration:qos [2017/05/22 08:41] (current) – dotoli
@@ Line 1: / Line 1: @@
 ====== QoS Quality of Service ======
-The amount of bandwith must not be higher as the real available interface bandwith. \\
+The ratio must not exceed 40:1 \\
-The ratio must not exceed 40/1 \\
 If there is only traffic for one queue it may use the unused bandwidth of the other queues\\
-The queue limits will only be enforced, if there is more data than fits through the main limit\\
+Only the output can be configured. \\
-**fixed Bandwidth ** \\
+**Bandwith: fixed (WWANX/WAN/OpenVPN) ** \\
 {{:configuration:qos_fixed.png?1200|}}
 example: \\
-high: TOS (Dec) 184 = DSCP (Dec), 46 (Hex) 0x2E / for voice \\
+high: TOS (Dec) 184 = DSCP (Dec), 46 (Hex) 0x2E / for voice application\\
-low:  TOS (Dec) 104 = DSCP (Dec), 26 (Hex) 0x1A / for video \\
+low:  TOS (Dec) 104 = DSCP (Dec), 26 (Hex) 0x1A / for video application\\
 default: All OTHER = not specified
-ratio: 19/6/1 = 26Mbit/s bandwidth. This is also the output limit. \\
+ratio: 19:6:1 = 26Mbit/s bandwidth. This is also the interface output limit. \\
+Because of this it is important to know the permanent throughput . \\
-QoS handels the packtes only if the configured upstream bandwidth has been reached\\
+QoS is no longer working if the throughput falls under 26Mbit/s  .\\
+**Bandwidth: auto(WWANX)  ** \\
+IP to ping: Configure a reachable host in the internet, preferably the target host. \\
+Based on the RTT the bandwith ratio is divided as follows: \\
+higest priority = 50%, \\
+middle priority = 45%, \\
+lowest priority = 5% \\

User Tools

Site Tools

Differences

Page Tools