This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
configuration:qos [2016/12/20 11:50] – dotoli | configuration:qos [2017/05/22 08:41] (current) – dotoli | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== QoS Quality of Service ====== | ====== QoS Quality of Service ====== | ||
- | |||
The ratio must not exceed 40:1 \\ | The ratio must not exceed 40:1 \\ | ||
If there is only traffic for one queue it may use the unused bandwidth of the other queues\\ | If there is only traffic for one queue it may use the unused bandwidth of the other queues\\ | ||
+ | Only the output can be configured. \\ | ||
- | + | **Bandwith: | |
- | **fixed | + | |
{{: | {{: | ||
example: \\ | example: \\ | ||
Line 14: | Line 13: | ||
ratio: 19:6:1 = 26Mbit/s bandwidth. This is also the interface output limit. \\ | ratio: 19:6:1 = 26Mbit/s bandwidth. This is also the interface output limit. \\ | ||
+ | Because of this it is important to know the permanent throughput . \\ | ||
+ | QoS is no longer working if the throughput falls under 26Mbit/ | ||
- | The queue limits will only be enforced, if there is more data than fits through | + | **Bandwidth: |
- | + | IP to ping: Configure a reachable host in the internet, preferably | |
- | + | Based on the RTT the bandwith | |
- | + | higest priority = 50%, \\ | |
- | + | middle priority = 45%, \\ | |
- | + | lowest priority = 5% \\ | |
- | + | ||
- | + | ||
- | + | ||
- | + | ||