Differences

This shows you the differences between two versions of the page.

--- configuration:extend-ethernet-port-with-vlan [2022/01/24 16:30] – [Configuration Switch] schmitt
+++ configuration:extend-ethernet-port-with-vlan [2022/02/09 15:45] (current) – [Advanced Configuration] schmitt
@@ Line 37: / Line 37: @@
 ==== IP Configuration ====
 Afterwards you need to define the IP Configuration of each VLAN Interface.
 You need to define the Mode of the VLAN Interface which can be LAN or WAN.
-In WAN Mode this link will be part of our link-managment for outgoing connections.
-In LAN Mode you will be able to be part of a local network and serve as a DHCP/DNS Server and so on.
+In WAN mode this link will be part of our link-managment for outgoing connections.
+In LAN mode you will be able to be part of a local network and serve as a DHCP/DNS Server.
 The IP address can be assigned statically or via DHCP. PPPoE is also possible for DSL-Modem scenarios-
@@ Line 60: / Line 63: @@
 This Configuration was done on a Netgear GS108E Plus Switch, but most of the managed switches have this function.
-As shown in the picture above, we will use Port 4 as the so called trunk. And Port 1,2 and 3 as the untagged Port
+As shown in the picture above, we will use Port 4 as the so called trunk. And Port 1,2 and 3 as the untagged Port.
 The Switch need to be configured to connect Ethernet Ports to the VLAN Trunk.
@@ Line 66: / Line 69: @@
 This is a portbased to tagBased VLAN conversion.
-As you can see in the table below Port 4 is member of every VLAN ID. And will hold the tagged Packages
+As you can see in the table below Port 4 is member of every VLAN ID. And will hold the tagged Packages.
-Port Port 1,2 and 3 is only part of every individual VLAN ID, which will have the untagged packages
+Port 1,2 and 3 is only part of every individual VLAN ID, which will have the untagged packages.
 {{ :configuration:vlan_switch.png?nolink |}}
-Entwurf: To configure this behavior you need to choose unttag/tagbased mode.....
+To configure this behavior you need to choose the port Membership either as tagged or as untagged.
+We have created this settings with the Netgear ProSafe Switch for you as an example.
+The following pictures show the configration. This menu can bereached at VLAN -> 802.1Q -> Advanced -> VLAN
+Membership.
+{{ :configuration:vlan_switch_tag.png?nolink |}}
+{{ :configuration:vlan_switch2_tag.png?nolink |}}
+{{ :configuration:vlan_switch3_tag.png?nolink |}}
-##############TODO###########  Bild mit Tagbases/portbased Config einfügen.
 ====Advanced Configuration====
-Supervision, because switch port state is not known.
+To check established connections, the router sends pings to a host at a user defined intervall. At Interfaces -> Supervision you can choose options like interface, host, ping intervall and emergency actions.
+{{ :configuration:vlan_supervision_settings.png?nolink |}}
+The Supervision page after configuration.
+{{ :configuration:vlan_supervision.png?nolink |}}
+For more details about configuration : [[config:link-supervision|Use the Link supervison for a stable connection]]

User Tools

Site Tools

Differences

Page Tools