Table of Contents
WLAN Client Bridge
To bridge a WLAN Client connection with a Ethernet LAN there are some requirements needed. The WiFi Access Point as well as the WiFi clients need to support 4 Address Frame. The configurtion is only possible with the following products:
- NB1800
- NB1810
- NB2700
- NB2710
- NB2800
- NB2810
- NB3700
- NB3701
- NB3710
- NB3711
- NB3800
Please use the current Version: 4.3.0.106. This funtionality was introduced with the NRSW 4.1.0.100. In case you running a NB800 or NB1601 you can take a look at our Mesh Network funtionality
Access Point Config
Please configure your WLAN Access Point as usual
At the IP Settings Page please enable the “4addr frame” and choose the LAN Interface you want to bridge with.
Client Config
Please configure your WLAN Client Connection as usual
Activating the CLient Bridge
After the WLAN Connection is set up. Please go to Interfaces→Link Managment and edit your WLAN Connection
Please define your local LAN Interface to bridge with.
