This is an old revision of the document!


Quick SetUp

NetModule routers can be easily set up by using the Web Manager. It is supported by the latest web browsers. Please ensure to have JavaScript turned on. Any submitted configuration via the Web Manager will be applied immediately to the system when pressing the Apply button. When configuring subsystems which require multiple steps (for instance WLAN) you can use the Continue button to store any settings temporarily and apply them at a later time. Please note, that those settings will be neglected at logout unless applied. The following steps need to be taken to establish your first Web Manager session and open up a Wifi network with an internet connection supplied by the SIM card provided. Further details could be found in the manual.

1. Insert the SIM Card into the slot SIM 1 and optionally add the antennas.


2. Connect the Ethernet port of your computer to the Ethernet1 port of the router using a standard CAT5 cable with RJ45 (or M12) connectors and plug in the router.


3. If not yet activated, enable DHCP on your computer’s Ethernet interface so that an IP address can be obtained automatically from the router. This usually takes a short amount of time until your PC has received the corresponding parameters You may track the progress by having a look to your network control panel and check whether your PC has correctly retrieved an IP address of the range 192.168.1.100 to 192.168.1.199.


4. Launch your web browser and go to the URL http://192.168.1.1.


5. Set a password for the admin user.


6. Go to Interfaces → Mobile → SIM and klick on the Edit button for SIM 1.

6.1. Insert the PIN code for the SIM card and click apply.

6.2. Go to Interfaces → Mobile → Interfaces and add a new WWAN interface.

6.3. Go to connection, choose your provider and click apply.


7. Go to WLAN → Administration and enable Administrative Status

7.1. For operational mode choose access point.

7.2. Under Regulatory Domain choose the country the Router is operated in.

7.3. Choose the number of antennas connected and give the antenna gain in decibel. The gain could be found in the data sheet of the antenna.

7.4. Choose the WLAN operation type (usually 802.11n).


8. Press continue and go to WLAN → Configuration

8.1. Press edit and add a name for your WLAN

8.2. Choose your security settings. Note the correct password lengths if a password security is chosen.


9. Press apply.