Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
wlan:qick:start [2020/05/18 08:51] fachet removed |
— (current) | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== WLAN Access Point Quick SetUp ====== | ||
| - | |||
| - | |||
| - | NetModule routers can be easily set up by using the Web Manager. It is supported by the latest web browsers. Please ensure to have JavaScript turned on. | ||
| - | Any submitted configuration via the Web Manager will be applied immediately to the | ||
| - | system when pressing the Apply button. When configuring subsystems which require | ||
| - | multiple steps (for instance WLAN) you can use the Continue button to store any | ||
| - | settings temporarily and apply them at a later time. Please note, that those settings | ||
| - | will be neglected at logout unless applied. | ||
| - | The following steps need to be taken to establish your first Web Manager session and open up a Wifi network with an internet connection supplied by the SIM card provided. Further details could be found in the manual. | ||
| - | ---- | ||
| - | 1. Insert the SIM Card into the slot SIM 1 and optionally add the antennas. | ||
| - | ---- | ||
| - | 2. Connect the Ethernet port of your computer to the Ethernet1 port of the router using a standard CAT5 cable with RJ45 (or M12) connectors and plug in the router. | ||
| - | ---- | ||
| - | 3. If not yet activated, enable DHCP on your computer’s Ethernet interface so that an IP address can be obtained automatically from the router. This usually takes a short amount of time until your PC has received the corresponding parameters You may track the progress by having a look to your network control panel and check whether your PC has correctly retrieved an IP address of the range 192.168.1.100 to 192.168.1.199. | ||
| - | ---- | ||
| - | 4. Launch your web browser and go to the URL http://192.168.1.1. | ||
| - | ---- | ||
| - | 5. Set a password for the admin user. | ||
| - | ---- | ||
| - | 6. Go to Interfaces -> Mobile -> SIM and klick on the Edit button for SIM 1. | ||
| - | |||
| - | 6.1. Insert the PIN code for the SIM card and click apply. | ||
| - | |||
| - | 6.2. Go to Interfaces -> Mobile -> Interfaces and add a new WWAN interface. | ||
| - | |||
| - | 6.3. Go to connection, choose your provider and click apply. | ||
| - | ---- | ||
| - | 7. Go to WLAN -> Administration and enable Administrative Status | ||
| - | |||
| - | 7.1. For operational mode choose access point. | ||
| - | |||
| - | 7.2. Under Regulatory Domain choose the country the Router is operated in. | ||
| - | |||
| - | 7.3. Choose the number of antennas connected and give the antenna gain in decibel. The gain could be found in the data sheet of the antenna. | ||
| - | |||
| - | 7.4. Choose the WLAN operation type (usually 802.11n). | ||
| - | ---- | ||
| - | 8. Press continue and go to WLAN -> Configuration | ||
| - | |||
| - | 8.1. Press edit and add a name for your WLAN | ||
| - | |||
| - | 8.2. Choose your security settings. Note the correct password lengths if a password security is chosen. | ||
| - | ---- | ||
| - | 9. Press apply. | ||