NetModule Router Wiki

User Tools

Site Tools

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
sdk:scripts:modbus-tcp-rtu-gateway [2022/06/28 12:10] – dodenhoeftsdk:scripts:modbus-tcp-rtu-gateway [2022/11/08 07:48] (current) – klueppel
Line 7: Line 7:
 DEV         = sprintf("SERIAL%d", (DEVIDX + 1)); DEV         = sprintf("SERIAL%d", (DEVIDX + 1));
 TCP_PORT    = 1502; TCP_PORT    = 1502;
 +DEBUG       = 0;
 +
 +
  
 /* check serial port config */ /* check serial port config */
Line 16: Line 19:
  
 /* set attributes */ /* set attributes */
-ret = nb_serial_setattr(DEV, 19200, 8, 1, 0, 0);+ret = nb_serial_setattr(DEV, 115200, 8, 1, 0, 0);
 if (ret != 0) { if (ret != 0) {
     nb_syslog("Could not set serial attributes: %d", ret);     nb_syslog("Could not set serial attributes: %d", ret);
Line 58: Line 61:
     exit(1);     exit(1);
 } }
 +if (DEBUG == 1) { 
 +    nb_modbus_set_debug(serial_fd, true);  
 +}    
 printf("Listening for connections on port %d\n", TCP_PORT); printf("Listening for connections on port %d\n", TCP_PORT);
 +
  
 tcp_client = -1; tcp_client = -1;
 registered = 0; registered = 0;
 +
  
 while (1) { while (1) {
Line 71: Line 78:
             sleep(1);             sleep(1);
             continue;             continue;
-        } +        } else { 
 +            if (DEBUG == 1) { 
 +                nb_modbus_set_debug(tcp_client, true); 
 +            } 
 +        }
     }     }
  
Line 100: Line 111:
             nb_syslog("Unable to extract payload (%s)", nb_modbus_last_error());             nb_syslog("Unable to extract payload (%s)", nb_modbus_last_error());
         } else {         } else {
 +            /* Modbus TCP - RTU must set the slave id */    
 +            ret = nb_modbus_set_slave (serial_fd, payload[0]);
 +            if (ret > 0) {
 +                nb_syslog("Unable to set modbus slave id");
 +                break;
 +            }
 +
             response = nb_modbus_send_raw(serial_fd, payload);             response = nb_modbus_send_raw(serial_fd, payload);
             if (is_void(response)) {             if (is_void(response)) {
Line 126: Line 144:
 close(serial_fd); close(serial_fd);
 exit(0); exit(0);
 +
 </code> </code>
  

Page Tools

sdk/scripts/modbus-tcp-rtu-gateway.1656418227.txt.gz · Last modified: 2022/06/28 12:10 by dodenhoeft