This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
configuration:wlan-client-bridge [2020/06/04 05:05] – [WLAN Client Bridge] dodenhoeft | configuration:wlan-client-bridge [2021/08/04 09:14] – external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== WLAN Client Bridge ====== | ====== WLAN Client Bridge ====== | ||
- | To bridge a WLAN Client connection with a Ethernet LAN there are some requierments needed. | ||
- | The Wifi Access Point need to Support the 4 Address Frame, which the AP in Netmodule Router does. | ||
- | * NB1800 - NB1810 | + | To bridge a WLAN Client connection with a Ethernet LAN there are some requirements needed. |
- | * NB2700 - NB2710 | + | The WiFi Access Point as well as the WiFi clients need to support 4 Address Frame. The configurtion is only possible with the following products: |
- | * NB2800 - NB2810 | + | |
- | * NB3700 - NB3701 - NB3710 - NB3711 | + | |
- | * NB3800 - | + | |
- | This Funtionality was introduced with the NRSW 4.1.0.100 so please | + | * NB1800 |
+ | * NB1810 | ||
+ | * NB2700 | ||
+ | * NB2710 | ||
+ | * NB2800 | ||
+ | * NB2810 | ||
+ | * NB3700 | ||
+ | * NB3701 | ||
+ | * NB3710 | ||
+ | * NB3711 | ||
+ | * NB3800 | ||
+ | |||
+ | Please | ||
+ | In case you running a NB800 or NB1601 you can take a look at our [[configuration: | ||
Line 35: | Line 43: | ||
{{ : | {{ : | ||
{{ : | {{ : | ||
+ | |||
+ | ==== Activating the CLient Bridge ==== | ||
+ | |||
After the WLAN Connection is set up. Please go to Interfaces-> | After the WLAN Connection is set up. Please go to Interfaces-> |