Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
Next revisionBoth sides next revision
configuration:wlan-client-bridge [2017/07/04 15:29] – created juraschekconfiguration:wlan-client-bridge [2021/11/08 14:37] – [Other HowTos] dodenhoeft
Line 1: Line 1:
 ====== WLAN Client Bridge ====== ====== WLAN Client Bridge ======
  
-To bridge a WLAN Client connection with a Ethernet LAN there are some requierments needed.  
-The Wifi Access Point need to Support the 4 Address Frame, which the AP in Netmodule Router does. 
  
-This Funtionality was introduced with the NRSW 4.0.1.103 so please use the current Version: [[ftp://share.netmodule.com/router/public/system-software/testing/4.0/4.0.1.106/|4.0.1.106]]+To bridge a WLAN Client connection with a Ethernet LAN there are some requirements needed.  
 +The WiFi Access Point as well as the WiFi clients need to support Address FrameThe configurtion is only possible with the following products:  
 + 
 +  * NB1800 
 +  * NB1810  
 +  * NB2700 
 +  * NB2710  
 +  * NB2800 
 +  * NB2810 
 +  * NB3700 
 +  * NB3701 
 +  * NB3710 
 +  * NB3711  
 +  * NB3800 
 + 
 +Please use the current Version: [[https://share.netmodule.com/public/system-software/4.3/4.3.0.106/|4.3.0.106]]. This funtionality was introduced with the NRSW 4.1.0.100. 
 +In case you running a NB800 or NB1601 you can take a look at our [[configuration:mesh-point|Mesh Network]] funtionality  
  
  
Line 20: Line 35:
  
  
-===== CLient Config Config =====+===== Client Config =====
  
 Please configure your WLAN Client Connection as usual Please configure your WLAN Client Connection as usual
Line 28: Line 43:
 {{ :configuration:screenshot_-_07042017_-_05_26_10_pm.png?nolink |}} {{ :configuration:screenshot_-_07042017_-_05_26_10_pm.png?nolink |}}
 {{ :configuration:screenshot_-_07042017_-_05_26_18_pm.png?nolink |}} {{ :configuration:screenshot_-_07042017_-_05_26_18_pm.png?nolink |}}
 +
 +==== Activating the CLient Bridge ====
 +
  
 After the WLAN Connection is set up. Please go to Interfaces->Link Managment and edit your WLAN Connection After the WLAN Connection is set up. Please go to Interfaces->Link Managment and edit your WLAN Connection
Line 35: Line 53:
 {{ :configuration:screenshot_-_07042017_-_05_26_29_pm.png?nolink |}} {{ :configuration:screenshot_-_07042017_-_05_26_29_pm.png?nolink |}}
 {{ :configuration:screenshot_-_07042017_-_05_26_40_pm.png?nolink |}} {{ :configuration:screenshot_-_07042017_-_05_26_40_pm.png?nolink |}}
 +
 +----
 +===== Other HowTos =====
 +[[configuration:mesh-point|Mesh Network]]
 +