Differences

This shows you the differences between two versions of the page.

--- configuration:wlan-client-bridge [2017/07/04 15:29]
juraschek created
+++ configuration:wlan-client-bridge [2020/10/01 07:40]
juraschek
@@ Line 1: / Line 1: @@
 ====== WLAN Client Bridge ======
 To bridge a WLAN Client connection with a Ethernet LAN there are some requierments needed.
-The Wifi Access Point need to Support the 4 Address Frame, which the AP in Netmodule Router does.
+The Wifi Access Point as well as the wifi clients need to support 4 Address Frame. The configurtion is only possible with the following products:
+  * NB1800
+  * NB1810
+  * NB2700
+  * NB2710
+  * NB2800
+  * NB2810
+  * NB3700
+  * NB3701
+  * NB3710
+  * NB3711
+  * NB3800
+Please use the current Version: [[ftp://share.netmodule.com/router/public/system-software/4.3/4.3.0.106/|4.3.0.106]]. This funtionality was introduced with the NRSW 4.1.0.100.
+In case you running a NB800 or NB1601 you can take a look at our [[configuration:mesh-point|Mesh Network]] funtionality
-This Funtionality was introduced with the NRSW 4.0.1.103 so please use the current Version: [[ftp://share.netmodule.com/router/public/system-software/testing/4.0/4.0.1.106/|4.0.1.106]]
@@ Line 20: / Line 35: @@
-===== CLient Config Config =====
+===== Client Config =====
 Please configure your WLAN Client Connection as usual
@@ Line 28: / Line 43: @@
 {{ :configuration:screenshot_-_07042017_-_05_26_10_pm.png?nolink |}}
 {{ :configuration:screenshot_-_07042017_-_05_26_18_pm.png?nolink |}}
+==== Activating the CLient Bridge ====
 After the WLAN Connection is set up. Please go to Interfaces->Link Managment and edit your WLAN Connection

User Tools

Site Tools

Differences

Page Tools