This shows you the differences between two versions of the page.
Next revision | Previous revision Next revision Both sides next revision | ||
configuration:wlan-client-bridge [2017/07/04 15:29] juraschek created |
configuration:wlan-client-bridge [2020/06/15 10:44] fachet |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== WLAN Client Bridge ====== | ====== WLAN Client Bridge ====== | ||
+ | |||
To bridge a WLAN Client connection with a Ethernet LAN there are some requierments needed. | To bridge a WLAN Client connection with a Ethernet LAN there are some requierments needed. | ||
- | The Wifi Access Point need to Support the 4 Address Frame, which the AP in Netmodule Router does. | + | The Wifi Access Point as well as the wifi clients need to support 4 Address Frame. The configurtion is only possible with the following products: |
+ | |||
+ | * NB1800 | ||
+ | * NB1810 | ||
+ | * NB2700 | ||
+ | * NB2710 | ||
+ | * NB2800 | ||
+ | * NB2810 | ||
+ | * NB3700 | ||
+ | * NB3701 | ||
+ | * NB3710 | ||
+ | * NB3711 | ||
+ | * NB3800 | ||
+ | |||
+ | Please use the current Version: [[ftp://share.netmodule.com/router/public/system-software/4.3/4.3.0.106/|4.3.0.106]]. This funtionality was introduced with the NRSW 4.1.0.100. | ||
+ | In case you running a NB800 or NB1601 you can take a look at our [[configuration:mesh-point|Mesh Network]] funtionality | ||
- | This Funtionality was introduced with the NRSW 4.0.1.103 so please use the current Version: [[ftp://share.netmodule.com/router/public/system-software/testing/4.0/4.0.1.106/|4.0.1.106]] | ||
Line 20: | Line 35: | ||
- | ===== CLient Config Config ===== | + | ===== Client Config ===== |
Please configure your WLAN Client Connection as usual | Please configure your WLAN Client Connection as usual |