Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
configuration:usb-autorun [2017/11/09 10:35] juraschek |
configuration:usb-autorun [2021/11/11 14:30] (current) dodenhoeft [Useful USB autorun] |
||
|---|---|---|---|
| Line 12: | Line 12: | ||
| - For running a script: ''autorun.sh'' | - For running a script: ''autorun.sh'' | ||
| - | ===== Example ===== | + | ===== Example autorun.key ===== |
| <code - autorun.key> | <code - autorun.key> | ||
| # corresponds to password in factory defaults | # corresponds to password in factory defaults | ||
| Line 20: | Line 20: | ||
| </code> | </code> | ||
| + | ===== Procedure ===== | ||
| + | The autorun feature need to be enabled. This is case case either in the factory state or when you have it enabled on purpose in the Config. | ||
| + | - Please do not plug in the USB Stick before the System is bootet completly (Status LED need to light steady green). | ||
| + | - After that pluging the USB Stick. | ||
| + | - If the Autorun was triggert correctly all LEDs need to flash GREEN at the same time | ||
| + | |||
| + | |||
| + | ===== Function is not always enabled ===== | ||
| + | |||
| + | Please keep in mind that the usb autorun function is not always enabled: | ||
| + | |||
| + | - It's enabled in Factory State until you define your admin password | ||
| + | - After that you need to enable it either via Webinterface or config parameter: ''autorun.status=1'' | ||
| + | |||
| + | ===== Useful USB autorun ===== | ||
| + | |||
| + | * [[configuration:firmware-update|Firmware update]] | ||
| + | * [[configuration:software-update|Software update]] | ||
| + | * [[configuration:config-update|Config update]] | ||