Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
configuration:qos [2016/12/20 11:32] dotoli |
configuration:qos [2017/05/22 08:41] (current) dotoli |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== QoS Quality of Service ====== | ====== QoS Quality of Service ====== | ||
| + | The ratio must not exceed 40:1 \\ | ||
| + | If there is only traffic for one queue it may use the unused bandwidth of the other queues\\ | ||
| + | Only the output can be configured. \\ | ||
| - | The amount of bandwith must not be higher as the available bandwith. \\ | + | **Bandwith: fixed (WWANX/WAN/OpenVPN) ** \\ |
| - | The ratio must not exceed 40/1 \\ | + | |
| - | + | ||
| - | + | ||
| - | **fixed Bandwidth ** \\ | + | |
| - | {{:configuration:qos_fixed_class.png?1200|}} | + | |
| {{:configuration:qos_fixed.png?1200|}} | {{:configuration:qos_fixed.png?1200|}} | ||
| - | |||
| example: \\ | example: \\ | ||
| - | high: TOS (Dec) 184 = DSCP (Dec), 46 (Hex) 0x2E / for voice \\ | + | high: TOS (Dec) 184 = DSCP (Dec), 46 (Hex) 0x2E / for voice application\\ |
| - | low: TOS (Dec) 104 = DSCP (Dec), 26 (Hex) 0x1A / for video \\ | + | low: TOS (Dec) 104 = DSCP (Dec), 26 (Hex) 0x1A / for video application\\ |
| default: All OTHER = not specified | default: All OTHER = not specified | ||
| - | ratio: 19/6/1 = 26Mbit/s bandwidth. \\ | + | ratio: 19:6:1 = 26Mbit/s bandwidth. This is also the interface output limit. \\ |
| - | + | Because of this it is important to know the permanent throughput . \\ | |
| - | QoS handels the packtes only if the configured upstream bandwidth has been reached\\ | + | QoS is no longer working if the throughput falls under 26Mbit/s .\\ |
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
| + | **Bandwidth: auto(WWANX) ** \\ | ||
| + | IP to ping: Configure a reachable host in the internet, preferably the target host. \\ | ||
| + | Based on the RTT the bandwith ratio is divided as follows: \\ | ||
| + | higest priority = 50%, \\ | ||
| + | middle priority = 45%, \\ | ||
| + | lowest priority = 5% \\ | ||