Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
configuration:qos [2016/12/20 11:44]
dotoli
configuration:qos [2017/05/22 08:41]
dotoli
Line 1: Line 1:
 ====== QoS Quality of Service ====== ====== QoS Quality of Service ======
  
-The amount of bandwith must not be higher as the real available interface bandwith. \\ 
 The ratio must not exceed 40:1 \\ The ratio must not exceed 40:1 \\
 If there is only traffic for one queue it may use the unused bandwidth of the other queues\\ If there is only traffic for one queue it may use the unused bandwidth of the other queues\\
 +Only the output can be configured. \\
  
- +**Bandwith: ​fixed (WWANX/​WAN/​OpenVPN) ​** \\
-**fixed ​Bandwidth ​** \\+
 {{:​configuration:​qos_fixed.png?​1200|}} {{:​configuration:​qos_fixed.png?​1200|}}
 example: \\ example: \\
-high: TOS (Dec) 184 = DSCP (Dec), 46 (Hex) 0x2E / for voice \\ +high: TOS (Dec) 184 = DSCP (Dec), 46 (Hex) 0x2E / for voice application\\ 
-low:  TOS (Dec) 104 = DSCP (Dec), 26 (Hex) 0x1A / for video \\+low:  TOS (Dec) 104 = DSCP (Dec), 26 (Hex) 0x1A / for video application\\
 default: All OTHER = not specified default: All OTHER = not specified
  
 ratio: 19:6:1 = 26Mbit/s bandwidth. This is also the interface output limit. \\  ratio: 19:6:1 = 26Mbit/s bandwidth. This is also the interface output limit. \\ 
 +Because of this it is important to know the permanent throughput . \\
 +QoS is no longer working if the throughput falls under 26Mbit/​s ​ .\\
  
-The queue limits will only be enforcedif there is more data than fits through ​the main limit\\ +**Bandwidth:​ auto(WWANX) ​ ** \\ 
- +IP to ping: Configure a reachable host in the internetpreferably ​the target host. \\ 
- +Based on the RTT the bandwith ratio is divided as follows: \\ 
- +higest priority = 50%, \\  
- +middle priority = 45%, \\ 
- +lowest priority = 5% \\
- +
- +
- +
- +