This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
configuration:qos [2016/12/20 11:33] dotoli |
configuration:qos [2016/12/21 09:22] dotoli |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== QoS Quality of Service ====== | ====== QoS Quality of Service ====== | ||
+ | The ratio must not exceed 40:1 \\ | ||
+ | If there is only traffic for one queue it may use the unused bandwidth of the other queues\\ | ||
+ | Only the output can be configured. \\ | ||
- | The amount of bandwith must not be higher as the available bandwith. \\ | + | **Bandwith: fixed (WWANX/WAN/OpenVPN) ** \\ |
- | The ratio must not exceed 40/1 \\ | + | |
- | + | ||
- | **fixed Bandwidth ** \\ | + | |
{{:configuration:qos_fixed.png?1200|}} | {{:configuration:qos_fixed.png?1200|}} | ||
example: \\ | example: \\ | ||
- | high: TOS (Dec) 184 = DSCP (Dec), 46 (Hex) 0x2E / for voice \\ | + | high: TOS (Dec) 184 = DSCP (Dec), 46 (Hex) 0x2E / for voice application\\ |
- | low: TOS (Dec) 104 = DSCP (Dec), 26 (Hex) 0x1A / for video \\ | + | low: TOS (Dec) 104 = DSCP (Dec), 26 (Hex) 0x1A / for video application\\ |
default: All OTHER = not specified | default: All OTHER = not specified | ||
- | ratio: 19/6/1 = 26Mbit/s bandwidth. \\ | + | ratio: 19:6:1 = 26Mbit/s bandwidth. This is also the interface output limit. \\ |
- | + | ||
- | QoS handels the packtes only if the configured upstream bandwidth has been reached\\ | + | |
- | + | ||
- | + | ||
- | + | ||
- | + | ||
- | + | ||
- | + | ||
- | + | ||
- | + | ||
+ | The queue limits will only be enforced, if there is more data than fits through the main limit.\\ | ||
+ | **Bandwidth: auto(WWANX) ** \\ | ||
+ | IP to ping: Configure a reachable host in the internet, preferably the target host. \\ | ||
+ | Based on the RTT the bandwith ratio is divided as follows: \\ | ||
+ | higest priority = 50%, \\ | ||
+ | middle priority = 45%, \\ | ||
+ | lowest priority = 5% \\ | ||
+ | **Interface: LANX** \\ | ||
+ | Configure an upstream/downstream limitation without QoS. |