This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
configuration:qos [2016/07/18 12:56] dotoli |
configuration:qos [2016/12/21 09:22] dotoli |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== QoS Quality of Service ====== | ====== QoS Quality of Service ====== | ||
- | 1.Set the Administrative Status to enabled \\ | + | The ratio must not exceed 40:1 \\ |
- | {{:configuration:qos_administration.png?600|}} \\ | + | If there is only traffic for one queue it may use the unused bandwidth of the other queues\\ |
- | 2.Configure the desired Bandwidth congestion: \\ | + | Only the output can be configured. \\ |
- | **Interface**: Select the desired inteface. \\ | + | **Bandwith: fixed (WWANX/WAN/OpenVPN) ** \\ |
- | **auto**: Qos manages the bandwith according the configured priority.(1=high/10=low). \\ | + | {{:configuration:qos_fixed.png?1200|}} |
- | IP to ping: A host is needed in order to measure the current bandwith. \\ | + | example: \\ |
- | **fixed**: QoS works with the configured settings. The amount of bandwith should never be higher as the available bandwith. \\ | + | high: TOS (Dec) 184 = DSCP (Dec), 46 (Hex) 0x2E / for voice application\\ |
- | {{:configuration:add_qos_interface_.png?600|}} \\ | + | low: TOS (Dec) 104 = DSCP (Dec), 26 (Hex) 0x1A / for video application\\ |
+ | default: All OTHER = not specified | ||
- | 3. Service configuration \\ | + | ratio: 19:6:1 = 26Mbit/s bandwidth. This is also the interface output limit. \\ |
- | auto: \\ | + | |
- | {{:configuration:qos_service.png?600|}} \\ | + | The queue limits will only be enforced, if there is more data than fits through the main limit.\\ |
- | fixed: \\ | + | |
- | {{:configuration:qos_service_fix.png?600|}} | + | **Bandwidth: auto(WWANX) ** \\ |
+ | IP to ping: Configure a reachable host in the internet, preferably the target host. \\ | ||
+ | Based on the RTT the bandwith ratio is divided as follows: \\ | ||
+ | higest priority = 50%, \\ | ||
+ | middle priority = 45%, \\ | ||
+ | lowest priority = 5% \\ | ||
+ | |||
+ | **Interface: LANX** \\ | ||
+ | Configure an upstream/downstream limitation without QoS. |