This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
configuration:wlan-client-bridge [2020/06/15 10:44] – fachet | configuration:wlan-client-bridge [2021/11/08 14:37] – [Other HowTos] dodenhoeft | ||
---|---|---|---|
Line 2: | Line 2: | ||
- | To bridge a WLAN Client connection with a Ethernet LAN there are some requierments | + | To bridge a WLAN Client connection with a Ethernet LAN there are some requirements |
- | The Wifi Access Point as well as the wifi clients need to support 4 Address Frame. The configurtion is only possible with the following products: | + | The WiFi Access Point as well as the WiFi clients need to support 4 Address Frame. The configurtion is only possible with the following products: |
* NB1800 | * NB1800 | ||
Line 17: | Line 17: | ||
* NB3800 | * NB3800 | ||
- | Please use the current Version: [[ftp:// | + | Please use the current Version: [[https:// |
In case you running a NB800 or NB1601 you can take a look at our [[configuration: | In case you running a NB800 or NB1601 you can take a look at our [[configuration: | ||
Line 43: | Line 43: | ||
{{ : | {{ : | ||
{{ : | {{ : | ||
+ | |||
+ | ==== Activating the CLient Bridge ==== | ||
+ | |||
After the WLAN Connection is set up. Please go to Interfaces-> | After the WLAN Connection is set up. Please go to Interfaces-> | ||
Line 50: | Line 53: | ||
{{ : | {{ : | ||
{{ : | {{ : | ||
+ | |||
+ | ---- | ||
+ | ===== Other HowTos ===== | ||
+ | [[configuration: | ||
+ | |||