This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
configuration:wlan-client-bridge [2018/03/20 14:59] – [WLAN Client Bridge] juraschek | configuration:wlan-client-bridge [2020/10/26 08:53] – fixed typos leuenberger | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== WLAN Client Bridge ====== | ====== WLAN Client Bridge ====== | ||
- | To bridge a WLAN Client connection with a Ethernet LAN there are some requierments needed. | ||
- | The Wifi Access Point need to Support the 4 Address Frame, which the AP in Netmodule Router does. | ||
- | This Funtionality was introduced | + | To bridge a WLAN Client connection |
+ | The WiFi Access Point as well as the WiFi clients need to support | ||
- | <WRAP center round important 80%> | + | * NB1800 |
- | In the DUAL Mode will only see SSID that are sending on the channel the AP is configured to | + | * NB1810 |
- | </ | + | * NB2700 |
+ | * NB2710 | ||
+ | * NB2800 | ||
+ | * NB2810 | ||
+ | * NB3700 | ||
+ | * NB3701 | ||
+ | * NB3710 | ||
+ | * NB3711 | ||
+ | * NB3800 | ||
+ | |||
+ | Please use the current Version: [[ftp:// | ||
+ | In case you running a NB800 or NB1601 you can take a look at our [[configuration: | ||
Line 25: | Line 35: | ||
- | ===== Client | + | ===== Client Config ===== |
Please configure your WLAN Client Connection as usual | Please configure your WLAN Client Connection as usual | ||
Line 33: | Line 43: | ||
{{ : | {{ : | ||
{{ : | {{ : | ||
+ | |||
+ | ==== Activating the CLient Bridge ==== | ||
+ | |||
After the WLAN Connection is set up. Please go to Interfaces-> | After the WLAN Connection is set up. Please go to Interfaces-> |