This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
configuration:qos [2016/12/21 09:06] dotoli |
configuration:qos [2017/05/22 08:41] (current) dotoli |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== QoS Quality of Service ====== | ====== QoS Quality of Service ====== | ||
- | |||
The ratio must not exceed 40:1 \\ | The ratio must not exceed 40:1 \\ | ||
Line 6: | Line 5: | ||
Only the output can be configured. \\ | Only the output can be configured. \\ | ||
- | **Bandwith: fixed ** \\ | + | **Bandwith: fixed (WWANX/WAN/OpenVPN) ** \\ |
{{:configuration:qos_fixed.png?1200|}} | {{:configuration:qos_fixed.png?1200|}} | ||
example: \\ | example: \\ | ||
Line 14: | Line 13: | ||
ratio: 19:6:1 = 26Mbit/s bandwidth. This is also the interface output limit. \\ | ratio: 19:6:1 = 26Mbit/s bandwidth. This is also the interface output limit. \\ | ||
+ | Because of this it is important to know the permanent throughput . \\ | ||
+ | QoS is no longer working if the throughput falls under 26Mbit/s .\\ | ||
- | The queue limits will only be enforced, if there is more data than fits through the main limit.\\ | + | **Bandwidth: auto(WWANX) ** \\ |
- | + | ||
- | **Bandwidth: auto ** \\ | + | |
IP to ping: Configure a reachable host in the internet, preferably the target host. \\ | IP to ping: Configure a reachable host in the internet, preferably the target host. \\ | ||
Based on the RTT the bandwith ratio is divided as follows: \\ | Based on the RTT the bandwith ratio is divided as follows: \\ | ||
Line 23: | Line 22: | ||
middle priority = 45%, \\ | middle priority = 45%, \\ | ||
lowest priority = 5% \\ | lowest priority = 5% \\ | ||
- | |||