This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
configuration:qos [2016/07/18 12:48] – dotoli | configuration:qos [2016/12/21 09:22] – dotoli | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== QoS Quality of Service ====== | ====== QoS Quality of Service ====== | ||
- | 1.Set the Administrative Status to enabled | + | The ratio must not exceed 40:1 \\ |
- | {{: | + | If there is only traffic for one queue it may use the unused bandwidth of the other queues\\ |
- | 2.Configure the desired Bandwidth congestion: | + | Only the output can be configured. \\ |
- | **Interface**: Select the desired inteface. \\ | + | **Bandwith: fixed (WWANX/WAN/OpenVPN) ** \\ |
- | **auto**: | + | {{: |
- | IP to ping: A host is needed in order to measure the current bandwith. \\ | + | example: |
- | **fixed**: | + | high: TOS (Dec) 184 = DSCP (Dec), 46 (Hex) 0x2E / for voice application\\ |
- | {{: | + | low: TOS (Dec) 104 = DSCP (Dec), 26 (Hex) 0x1A / for video application\\ |
+ | default: All OTHER = not specified | ||
- | 3. Service configuration | + | ratio: 19:6:1 = 26Mbit/s bandwidth. This is also the interface output limit. \\ |
- | {{:configuration:qos_service.png?600|}} | + | |
+ | The queue limits will only be enforced, if there is more data than fits through the main limit.\\ | ||
+ | |||
+ | **Bandwidth: auto(WWANX) | ||
+ | IP to ping: Configure a reachable host in the internet, preferably the target host. \\ | ||
+ | Based on the RTT the bandwith ratio is divided as follows: \\ | ||
+ | higest priority = 50%, \\ | ||
+ | middle priority = 45%, \\ | ||
+ | lowest priority = 5% \\ | ||
+ | |||
+ | **Interface: | ||
+ | Configure an upstream/ |