This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
configuration:gre [2016/08/15 07:19] – dotoli | configuration:gre [2016/08/15 08:55] – dotoli | ||
---|---|---|---|
Line 2: | Line 2: | ||
- | Configure of Box1 TAP mode: | + | **TUN mode:**\\ |
- | config.version=1.8 | + | {{: |
- | config.product=1600 | + | |
- | network.hostname=NB1600 | + | Peer address: Public IP address of the remote station (NB1600-X, cisco router |
- | cert.settings.phrase=[enc] | + | Local tunnel address/ |
- | wwan.0.status=1 | + | Remote network: Destination network / Network of the remote router\\ |
- | wwan.0.card=0 | + | |
- | wwan.0.sim=0 | + | |
- | wwan.0.number=*99* | + | **TAP mode:**\\ |
- | wwan.0.username=testprofil | + | |
- | wwan.0.password=[enc] | + | {{: |
- | wwan.0.apn=corporate.swisscom.ch | + | |
- | wwan.0.auth=3 | + | Peer address: Public IP address of the remote station (NB1600-X, cisco router |
- | wwan.0.hdrcomp=0 | + | Bridge interface: LANX; the IP address |
- | wwan.0.softcomp=0 | + | |
- | wwan.0.isdn=0 | + | |
- | usb.status=0 | + | |
- | usb.0.enabled=0 | + | |
- | usb.1.enabled=0 | + | |
- | autorun.status=0 | + | |
- | cliphp.status=0 | + | |
- | network.lan.1.address=192.168.4.1 | + | |
- | network.dhcp.0.end=192.168.1.120 | + | |
- | network.dhcp.1.start=192.168.4.100 | + | |
- | network.dhcp.1.end=192.168.4.199 | + | |
- | wanlink.0.mode=1 | + | |
- | wanlink.0.name=wwan0 | + | |
- | wanlink.0.prio=1 | + | |
- | wanlink.0.weight=0 | + | |
- | gre.status=1 | + | |
- | gre.tunnel.0.mode=1 | + | |
- | gre.tunnel.0.type=tap | + | |
- | gre.tunnel.0.peer=138.188.50.3 | + | |
- | gre.tunnel.0.brdev=lan0 | + | |
- | admin.password=[enc] | + | |
- | ssh.port=2222 | + | |
- | telnet.port=2323 | + | |
- | **Configure of Box2: | ||
- | ** | ||
- | {{: |