This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
app-notes:hayes-modem-at-simulator [2018/05/08 17:05] – [Concept] cakir | app-notes:hayes-modem-at-simulator [2018/05/08 17:08] – [Configuration] cakir | ||
---|---|---|---|
Line 19: | Line 19: | ||
This way you can provide the old legacy functionality over modern IP Connections. Depending on your infrastructure you could secure your communication with a VPN Layer or work straight with public IP addresses. | This way you can provide the old legacy functionality over modern IP Connections. Depending on your infrastructure you could secure your communication with a VPN Layer or work straight with public IP addresses. | ||
- | ===== Adressing | + | ===== Addressing |
An important Part on the Dial-In/ | An important Part on the Dial-In/ | ||
- | The old addressing concept were based on phone numbers. With the Modem Emulator the Adresses | + | The old addressing concept were based on phone numbers. With the Modem Emulator the Addresses |
- | But for backward | + | But for backward |
===== Configuration ===== | ===== Configuration ===== | ||
Line 41: | Line 41: | ||
Please set the Baud Rate accordingly to you attached device. Also set the " | Please set the Baud Rate accordingly to you attached device. Also set the " | ||
- | Any incoming connection will be received on the TelnetPort configured. This Port need also to be accessible on the IP Adress | + | Any incoming connection will be received on the TelnetPort configured. This Port need also to be accessible on the IP Address |
- | The Phonebook section of the configuration will keep the aliases of any Phonenumbers so that you don't need to reconfigure you device and can use the old adressing | + | The Phonebook section of the configuration will keep the aliases of any Phonenumbers so that you don't need to reconfigure you device and can use the old addressing |
The new dial command would be: | The new dial command would be: |